Has anyone connected a generic 3DTouch to an Ender 3 with a stock 1.1.3 mobo? The cables that are supposed to be connected instead of the Z-axis endstop are signal + GND

Ender 3 installation bltouch - Switching wires - Switching out the ground wire and z min wire.

Creality Ender 3 (Pro) & BLTouch: How to Install It

3D Printers, 3D Printers & Supplies, Computers/Tablets & Networking - PicClick UK

Complete BL Touch install guide - no wires cut, no adapter needed but speaker physically disabled : r/ender3

How can I fix this without buying an X axis cable? The connector that goes to the x axis stop switch broke when unpacking and now I don't know how to connect

creality ender 3 - Problems with Z-axis: Z-axis raised not enough at the beginning - 3D Printing Stack Exchange

Creality Official Ender 3 S1 3D Printer, Upgraded Direct Drive FDM 3D Printers, Quick Assembly, with Auto Leveling Bed, Dual Z-axis Screws, Spring Steel Print Bed, Build Size 220x220x270 mm

It's Creality original Suitable for Ender 3 Ender 3 Pro

Creality 3D Printer XYZ Axis Stepper Motor and Limited Switch Endstop Cable for Ender 3 Ender 3 Pro (Pack of 3)

Total cable length：X/E Axis: about 790mm/31inch(the longest terminal about 900mm/35.4inch),Y Axis:about 400mm/15.7inch, Z Axis: about 300mm/11.8inch.

FYSETC 3D Printer Parts Ender 3 Stepper Motor Cable XYZ Axis Stepper Motor and Limited Switch Endstop Cable for Ender 3/ Ender 3 Pro/Ender 3X-3Pcs

Has anyone connected a generic 3DTouch to an Ender 3 with a stock 1.1.3 mobo? The cables that are supposed to be connected instead of the Z-axis endstop are signal + GND

Bltouch 1.3.1 without adapter board auto home issue on 4.2.2 board - z axis moves in one direction : r/ender5

Confused by this setup, Verizon tech installed this splitter which splits to the Verizon router and the STBs. The Verizon router is currently being used as a MoCA bridge and my UniFi